Benelli TNT 25 Maintenance Manual page 264

Disassembling Shaft Sleeve Bearing
•Knock out the bearing [A] from one side of wheel.
Special Tools—Complete Set of Tools for Installing Bearing:
Installing Shaft Sleeve Bearing
•Replace one new bearing.
•Press bearing [A] towards the inside, until it reaches the top.
Special Tools—Complete Set of Tools for Installing Bearing [B]:
•Apply high-temperature grease to the bearing.
•Replace one new oil seal.
•When pressing it into the new oil seal, the sealing surface should be
aligned at the end of hole.
○Apply high-temperature grease to the edge of oil seal.
Special Tools—Complete Set of Tools for Installing Bearing:
6-30