Starter Motor - Benelli TNT 25 Maintenance Manual

Starter Motor

Before the starter motor is disassembled, turn "OFF" the main
switch, remove the bond strap of battery, and then turn on the
power to see whether the motor runs to confirm safety.
Do not pat the starter motor shaft or body, otherwise the motor
body may be damaged
Starter Motor Disassembly
●Disassemble the starter motor lead terminal nut
●Disassemble the starter motor mounting bolt
● Remove the starter motor from the left side
Starter Motor Inspection
Start the engine according to the following conditions
Condition:
Gear → neutral
Clutch handle → release
Side stand → down
●Turn on the ignition switch and press the start button
○If other starting system circuits are normal, but the starter motor
does not start. Remove the starter motor and directly connect it to
the positive and negative electrodes of storage battery; if it can run
normally, it is the engine Matching problem: if it does not run, the
starter motor is broken.
Carbon Brush Inspection
●Measure the length [A] of each carbon brush [B]
★If any carbon brush has reached the service limit, replace the
carbon brush plate assembly as a set.
Length of Starter Motor Carbon Brush
Standard: 10 mm
Service limit: 5.0 mm
*Note
*Note
7-22