Brake Master Cylinder - Benelli TNT 25 Maintenance Manual

Brake Master Cylinder

Disassembling Front Brake Master Cylinder
•Disassemble the mounting bolt of front Brake Master Cylinder [A].
•Disconnect the connector of front brake lamp switch [E].
Note
If brake fluid spills out, please rinse immediately!
•Disassemble:
Brake handle/pedal pivot bolt [B] and locking nut [C]
Brake handle/pedal [A],
front brake lamp switch mounting bolt [B], flat washer [F] and
spring washer [G]
Front brake lamp switch [D]
Front Brake Master Cylinder [H]
Installing Front Brake Master Cylinder
•Install:
The operations should be conducted in reverse order of disassembly.
•First tighten the upper tightening bolts and then the lower
tightening bolts.
Locking Torque of Front Main Cylinder Tightening Bolt: 11 N•m
•Replace the gaskets on both sides of the hose joint with new ones.
•Locking torque:
Locking Torque of Banjo bolt of Brake Hose: 25 N•m
•Exhaust air from the brake pipe (see "Air Bleeding in the Brake Pipe").
•Check whether the braking performance of the brakes is normal and the brake fluid leaks.
6-47