Table of Contents
Advertisement
●Removing:
Clamp [A]
Hose [B],
Bolt [D],
Reserve tank [C],
Overflow hose [F],
●Remove the cover [E] and pour the coolant into a container.
●Install the reserve tank [C] and install the hose [B] of reserve tank
and overflow hose [F] back correctly.
●Tighten the bolt [D].
Tightening torque of reserve tank bolt: 9.8 N·m
●Tighten the drain bolt (with gasket).
○Replace the gasket of drain bolt.
Tightening torque of coolant drain bolt: 10 N·m
●Add coolant to the radiator until the level reaches the filler neck [A]
of radiator and then close the radiator cap.
○Slowly pour the coolant to exhaust the air in the engine and
radiator.
●Pour the coolant until the level reaches the full level of fluid
storage tank and then close the cover.
Use the recommended coolant (Benelli part No.: 06109P250000)
preferentially. If other coolant is used, the engine may be
damaged or the performance of engine may be reduced.
The antifreeze in the cooling system must be soft water or
distilled water. If the hard water is used in the cooling system, the
incrustation will deposit in the water pipe, which will greatly
reduce the efficiency of cooling system.
Remark
Note
Note
2-55
Advertisement
Table of Contents
Troubleshooting
