Checking Brake Lamp Switch - Benelli TNT 25 Maintenance Manual

Checking Brake Lamp Switch

●Turn on the main switch..
●After the brake handle is applied for 20mm or the brake pedal is
depressed for about 25mm, the brake lamp shall be on.
★If the brake lamp is not on, check or replace the following parts:
Battery (see "Checking Charging Situation" in "Electrical System");
Brake lamp (see "Disassembling Tail Lamp/Brake Lamp" in "Electrical System" chapter);
30A main fuse and 10A tail lamp fuse (see "Checking Fuse" in "Electrical System" chapter);
Front brake lamp switch [A] (see "Checking Switch" in "Electrical System" chapter);
Rear brake lamp switch [A] (see "Checking Switch" in "Electrical System" chapter);
Wire harness (see "Checking Circuit" in "Electrical System" chapter)
2-36