Checking Fuel Evaporation And Recovery System (Chinese, European And Us Models) - Benelli TNT 25 Maintenance Manual

• Check whether the connection of hose joint is firm.
〇Push and pull the hose joint [A] for more than twice to ensure that
the hose joint is fixed firmly.
★If the connection is not firm, install the hose joint again.
Warning
Slide the joint to ensure that the hose joint is properly installed
on the fuel supply pipe, otherwise the fuel leakage may occur.
Checking Fuel Evaporation and Recovery System (Chinese,
European and US Models)
• Check the carbon canister solenoid valve according to the
following steps.
〇Remove the seat (see "Seat Disassembly" in "Frame" chapter).
〇Remove the right side cover (see "Side Cover Disassembly" in
"Frame" chapter).
〇Remove the battery (see "Battery Disassembly" in "Battery"
chapter).
〇Remove the carbon canister solenoid valve bracket B.
〇Remove the hose [1] used to connect separator and remove the
carbon canister solenoid valve [D] from the right side of motorcycle.
〇Check whether there are cracks or other damages on the carbon
canister solenoid valve.
★If any, it must be replaced.
★Check the carbon canister solenoid valve (see "Carbon Canister
Solenoid Valve" in "Fuel Injection System (EFI)")
2-15