Table of Contents
Advertisement
Installing Rear Wheel
•Apply high temperature grease to the edge of oil seal.
•Put shaft sleeve at two sides of hub.
Shaft sleeve at right side [A]
Shaft sleeve at left side [B]
•Install drive chain at the rear sprocket.
•Install calipers bracket [A] to the swing arm stop block [B].
•Insert the rear shaft from the left side of wheel, and then tighten rear
shaft nut.
Locking torque of Rear Wheel Axle nut: 150N·m
•Adjust the slackness of drive chain after installing the rear wheel
(see "Regular Maintenance"—"Check the Slackness of Drive
Chain").
• Install the rear calipers (see "Brake" —"Installing Calipers").
• Mount the rear wheel speed sensor.
• Check whether the rear brake is normal (see "Regular
Maintenance"—"Check Whether the Brake is Normal").
Warning
Tread on brake pedal, until the Brake Pads is against the brake
disc, so that the brake pedal can function as normal. Do not
ride the motorcycle before you complete the above steps!
Because if you do not complete the above operation, brake may
not work normally when being used for the first time and thus
danger is caused.
6-13
Advertisement
Table of Contents
Troubleshooting
