Installing Drivers For Microsoft Windows Nt 4.0 Systems - ADIC Scalar 100 User Manual
Quantum scalar 100: user guide
Hide thumbs
Also See for Scalar 100:
- User manual (346 pages) ,
- Quick start manual (2 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
12 In the Device Manager window, ensure that the appropriate device is listed under Tape Devices entry.
The listings differ, depending on your library type:
•
AIT-2: SONY SDX-500C Sequential Device
•
AIT-3: SONY SDX-700C Sequential Device
•
LTO-1: IBM ULTRIUM-TD1 SCSI Sequential Device
•
LTO-2: IBM ULTRIUM-TD2 SCSI Sequential Device
•
LTO-3: IBM ULTRIUM-TD3 SCSI Sequential Device
•
SDLT-220: Quantum SDLT1 SCSI Sequential Device
•
SDLT-320: Quantum SDLT320 SCSI Sequential Device
•
SDLT-600: Quantum SDLT600 SCSI Sequential Device
Installing Drivers for Microsoft Windows NT 4.0 Systems
When using Microsoft® Windows NT® 4.0, you only need to install the tape drive device driver. There are
no medium changer drivers necessary for Windows NT 4.0.
There are no tape drive device drivers available for LTO-2 libraries in an
Note
Windows NT 4.0 environment.
Follow the steps below to install the Windows NT 4.0 driver:
1
Ensure the library is powered on and fully booted.
2
Connect the library to the host and then restart the host.
3
Obtain the appropriate drivers. You may need to consult your service representative.
4
In the Control Panel, double-click the Tape Devices icon.
If the host server or workstation already has drivers installed, continue with
Note
the next step, otherwise, skip the next two steps.
5
Select the Drivers tab and then select Add.
6
Select Have Disk.
7
Type x:\drivers \nt4, replacing x with the path to the drivers you obtained in
8
Select the appropriate drive type:
•
AIT-2: SONY AIT Tape Drive (NT 4.0)
•
AIT-3: SONY AIT Tape Drive (NT 4.0)
•
LTO-1: IBM Ultrium Tape Drives (OEM)
•
LTO-2: Not Supported
•
SDLT-220: QUANTUM DLT/SuperDLT Driver for NT4 - Ver 2.0
•
SDLT-320: QUANTUM DLT/SuperDLT Driver for NT4 - Ver 2.0
9
Select OK.
10 When the New SCSI Tape Device Found dialog box appears, click OK.
11 If prompted, type the path to the drivers once again and click Continue.
Required files will now be installed for the driver.
Scalar 100 User's Guide
Step
3.
21
Advertisement
Table of Contents
