Table 4
Available Library Information
Get retries
Put retries
a. The storage slot, mailbox slot, and drive maximum value may be different for your library, depending on your
configuration and your drive type.
Path: Main Menu > Status > Library > System
•
From the main menu, select Status and then select Library. Select System.
The library information appears. Refer to
Getting Firmware and Serial Number Information
Use About to display the library serial number and the application and boot firmware levels. This includes
the library, picker, display, drive, and RMU.
Path: Main Menu > More > About > (Details)
1
From the main menu, select More. Select About.
The library serial number and library firmware level appears.
2
Select Details.
The library, picker, and display application and boot codes are displayed.
3
Continue selecting Details to scroll through the available information:
All application and boot code entries should be of the same version and at
Note
the highest level.
•
MainAppl — the library application code.
•
PickAppl — the picker application code.
•
DispAppl — the display application code.
•
MainBoot— the library boot code.
•
PickBoot — the picker boot code.
•
DispBoot — the display boot code.
•
Sled<x>Appl — the drive module application code, where X is the drive module number.
•
Sled<x>Boot — the drive module boot code, where X is the drive module number.
•
RMU Appl — the Remote Management Unit (RMU) application code.
48
0 to 65535
0 to 65535
Table 4
The lifetime number of recovery retries on a
get command.
The lifetime number of recovery retries on a
put command.
on page 47 for information on each of these fields.
Getting Information