Windows Nt® 4.0 Driver File Installation - ADIC Scalar 24 Installation And Operation Manual

Windows NT® 4.0 Driver File Installation
1 Click the Start button, point to Settings, then click Control Panel.
2 Double-click the Tape Devices icon.
If the host server or workstation already has drivers installed, continue with the
Note
next step, otherwise, skip the next two steps.
3 Click the Drivers tab.
4 Click the Add button.
5 Click the Have Disk button.
6 Type in the path to the appropriate drivers on the Scalar 24 Documentation and Software CD, replacing
x: with the drive letter of the CD-ROM drive. Available options are:
LTO-1: x:\drivers\nt4\LTO
LTO-2: not supported
SDLT320: x:\drivers\nt4\SDLT
7 Click on the appropriate drive entry and then click the OK button. Available options are:
LTO-1: IBM Ultrium Tape Drives (OEM)
LTO-2: not supported
SDLT320: Quantum DLT/SuperDLT Driver for NT4 - Ver 2.0
8 When the New SCSI Tape Device Found dialog box opens, click OK.
Required files will be installed for the driver now.
9 If you have multiple drives of this type, click OK at each prompt to install the driver for each device.
10 When the driver has been installed for all devices, click the OK button in the Tape Devices dialog box.
11 Restart the host server or workstation.
12 After restarting, click the Start button, point to Settings, click Control Panel, double-click the Tape
Devices icon, and verify that the drivers were properly loaded.
Scalar 24 Installation and Operation Guide 27