What Type Of Terminator Is Required; Where Are The Drivers Located; How Do I Manually Remove A Tape; More Faqs - ADIC Scalar 24 Installation And Operation Manual

What type of terminator is required?

Your Scalar 24 comes with a compatible terminator. The Scalar 24 is a LVD/SE SCSI device, so
only use an LVD/SE terminator. There are several different types of terminators. Some terminators
have LEDs. If you are using a terminator with an LED and it is illuminated in red, check the LED key
on the terminator and ensure that you have the correct type of terminator.
For more information on connecting a terminator to your Scalar 24, see
on page 4-2.

Where are the drivers located?

Drivers for your Scalar 24 can be found on the CD-ROM in the drivers directory. For the latest
drivers, check the Scalar 24 website at
the drivers, please contact ATAC.

How do I manually remove a tape?

There are four places within the Scalar 24 where you may want to manually remove a tape. You
can remove a tape manually from a drive, the rear slots, the magazines, and the picker. Refer to
Manual Removal of Tapes

More FAQs

The following are questions you may encounter when operating your Scalar 24.

Where are the Error Messages defined?

Hard errors are listed in the Error Log which can be accessed through the Status menu. All errors,
diagnostic alerts, and events are accessible by outputting logs to the serial port. For more
information on outputting logs, see
For more information on specific error messages, see
6-2
www.adic.com/scalar
on page 9-5.
Output Logs on page 8-74.
Connecting to a SCSI Bus
24. If you need assistance installing
Scalar 24 Error Messages
Scalar 24
on page 9-2.
62-2301-02 Rev A