4
Install the cables between the bottom drive and the library controller and between the Library Controller
and the host. Refer to
If you have more than one SCSI bus, connect a cable between the bottom drive on the SCSI bus to the
host.
Figure 7
SCSI Cabling in a Library Control Path Library
Cabling Drive Control Path Libraries
There are two ways to cable Drive Control Path libaries: SCSI cables or Fibre cables. For specific SCSI and
Fibre connection information, refer to
Connecting the Power and Fibre Cables in a Drive Control Path
Library
1
Connect the power cord to the power outlet on the rear of the library.
2
Install a Fibre cable between the bottom drive Fibre port and the host. Refer to
Repeat for each additional drive installed.
The Fibre cable can be connected from the drive to a switch rather than a
Note
host.
16
Figure
7.
Host Attachment
on page 11.
Figure
8.
Setting up your Scalar 100