Replacing A Drive; Installing A Secondary Power Supply - ADIC Scalar 100 User Manual
Quantum scalar 100: user guide
Hide thumbs
Also See for Scalar 100:
- User manual (346 pages) ,
- Quick start manual (2 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
Replacing a Drive
If you have difficulties installing or replacing a drive, try resetting the drive and/
Note
or rebooting the library and host. Also, ensure that the new drive uses a unique
SCSI ID or Loop ID, as appropriate.
1
Remove the existing drive. (Refer to
2
Install the new drive. (Refer to
3
If your library is an LTO-1 HVD, notify the library that a drive has been replaced using the operator
panel:
Main Menu > More > Service > Drives > Repair > Replace
Note that the drive will remain off the bus until the library has set the SCSI ID or
Note
Loop ID of the drive.
Installing a Secondary Power Supply
Use the following instructions to install a secondary power supply.
Tools required:
•
none
Scalar 100 User's Guide
Removing a Drive
Installing a Drive
on page 27.)
on page 28.)
29
Advertisement
Table of Contents
