Installing Drivers For Windows 2000 And Windows Server 2003; Installing The Windows Server 2003 Library Driver; Installing The Windows 2000 Library Driver; Installing The Windows 2000 Or Windows Server 2003 Drive Driver - ADIC SCALAR 24 Installation And Operation Manual

Installing Drivers for Windows 2000 and Windows Server 2003

®
When using Microsoft Windows
driver required for the Scalar 24. The Scalar 24 can operate using the standard media changer driver
provided with the Windows Removable Storage Manager (RSM). Windows will still try to locate a suitable
driver using the Found New Hardware Wizard, so when this wizard opens, follow the instructions below to
complete the setup.
The tape drives inside the library require special drivers. First check the host application documentation for
special drive driver requirements. Follow the instructions provided with that application to load the
appropriate driver. If none are specified, refer to the drive manufacture's website for the most current device
driver. Follow the instructions below to install the drive driver.

Installing the Windows Server 2003 library driver

1 When the Found New Hardware Wizard starts up, give it permission to install the device software
automatically, then select Next.
2 After it searches and fails to find the necessary device software, leave the checkbox checked. This
prevents Windows from prompting you again to install software for the device.
3 Select Finish to complete the installation.

Installing the Windows 2000 library driver

1 When the Found New Hardware Wizard starts up, select the Next button to continue with the wizard.
2 Allow Windows to search for a suitable driver and then select Next.
3 De-select all of the additional locations to search for the driver and then select Next.
4 After it has failed to find a suitable driver, select the option to disable the device and then select Finish.
Disabling the device does not affect functionality, since a driver is not required for operation.

Installing the Windows 2000 or Windows Server 2003 drive driver

1 Ensure the library is powered on and fully booted.
In Windows Server 2003, the library and/or tape drive drivers may come pre-
Note
installed. If so, it will be automatically loaded for the appropriate devices.
2 Connect the library to the host and then restart the host.
3 Obtain the appropriate drivers. You may need to consult your service representative.
4 Start Device Manager. (..\WINNT\system32\devmgmt.msc)
5 In the navigation pane, locate the appropriate device for your library drive type:
• LTO-1: IBM ULTRIUM-TD1 SCSI Sequential Device
• LTO-2: IBM ULTRIUM-TD2 SCSI Sequential Device
• LTO-3: IBM ULTRIUM-TD3 SCSI Sequential Device
• SDLT-320: Quantum SDLT320 SCSI Sequential Drive
• SDLT-600: Quantum SDLT600 SCSI Sequential Drive
6 Right-click on the appropriate device and select Properties.
7 On the Driver tab, select Update Driver.
This starts the Upgrade Device Driver Wizard.
20
®
2000 and Windows Server 2003 native backup, there is no special library
Getting Started