Table of Contents
Advertisement
Installing the SNC 6101 in a Scalar 100
To install the SNC 6101
1
Power down your Scalar 100 and disconnect the AC power cord from the voltage source.
2
At the rear of the Scalar 100, find the bottom, left filler plate (see
3
Remove the filler plate by unscrewing the two thumb screws identified in
Save this filler plates for future use. If the SNC 6101 is removed, the
CAUTION
empty slot must always be covered to prevent debris from entering
the equipment and to enable proper air circulation for cooling.
4
Position the SNC 6101 module as shown in
modem ports are positioned at the top.
5
Align the top and bottom rails of the SNC 6101 with those on the Scalar 100 and slide the module into
the chassis until it is flush.
The mounting rails prevent the SNC 6101 from being inserted wrong side
Note
up.
Figure 4
Scalar 100 Filler Plate Removal
16
Figure
Figure 5
on page 17. Make certain the two RJ-45 and null
4).
Figure
4.
Installation
Advertisement
Table of Contents
