Library Controller (Library Control Path Only); Rear Power Switch - ADIC Scalar 100 User Manual
Quantum scalar 100: user guide
Hide thumbs
Also See for Scalar 100:
- User manual (346 pages) ,
- Quick start manual (2 pages) ,
- Release note (2 pages)
Table of Contents
Advertisement
Figure 4
Back Panel Components of Drive Control Path Libraries
Library Controller (Library Control Path only)
The library controller is part of Library Control Path libraries. The library controller controls all operations in
the library, including the interaction between the library and operators. The library firmware on the library
controller creates and maintains the library configuration, the physical location of the robotic system, and
the inventory of cartridges. The resulting database is maintained in library controller memory.
The SCSI connections are located on the library controller. A switch on the library controller allows you to
switch your library between LVD and HVD connections.
Rear Power Switch
Turning off the rear power switch removes all power from the library. Turn off the rear power switch
whenever you are servicing your library. In the event of danger to personnel or property, immediately turn
off the rear power switch.
However, except in emergencies, use the normal shutdown procedure before switching off the rear power
switch. ADIC is not responsible for damage caused by improper use of the rear power switch. This risk lies
entirely with the user.
Scalar 100 User's Guide
7
Advertisement
Table of Contents
