Running The Self Test - Primera Pictura 310s User Manual

B. Running
the Self Test the Self Test
24
Now that print supplies are installed and power is
applied, a self test should be performed to check
for proper operation of the printer. The Color Sign
Printer is capable of doing a specific self test print
for 3-color resin, wax thermal transfer, and dye-
sublimation. To tell your printer which type of self
test you would like it to print, simply configure the
small switches on the printerÕs rear panel
accordingly.
If you have a 3-color resin ribbon and #300-Series
print media installed, leave all switches set at their
default position of switches 1 and 2 DOWN and
the rest of the switches UP.
If you have a wax thermal transfer ribbon and
print media installed, flip all switches UP and turn
the printer power OFF and ON to reset the printer.
If you have #200-Series dye-sublimation supplies
installed, flip only switch 2 down and turn the
printer power OFF and ON to reset the printer.
Once you have selected the type of self test you
would like to print, refer to the following steps to
initiate the self test print.
1.
Make sure the appropriate supplies are
properly loaded, that power is ON, and that the
Top Cover is shut.
2.
Press and release the cancel button. Notice the
on-line light turns off momentarily just after the
cancel button is pressed.
3.
Immediately after pressing the cancel button,
while the on-line light is momentarily off, press
and hold the on-line button until the printer begins
to feed a sheet of print media.