Printing Aself Test - Primera Inscripta User Manual

TOC
D. PRINTING A
Now that the printer is set up and print supplies are loaded, a
self test should be performed to check for proper operation of
the printer. A sample of the self-test print is shown below.
Refer to the following steps to run a self test:
1. If power has already been applied, remove it by
unplugging the power plug on the rear panel of the printer.
The
loaded and that a CD has been placed in the
Also, disconnect the interface cable from the printer if
connected.
2. Press and hold the
plug into the power jack.
3. Continue to hold the CD Tray button down for a few
seconds, until you hear the self-test begin to print.
SELF TEST
LED status light
CD Tray button
should be OFF. Verify that a ribbon is
as you insert the power
Ink Ribbons and Optical Media 11
INDEX
CD Tray.