Primera Pictura 310s User Manual page 70

photos and complex graphics take longer to raster
than images composed primarily of text or simple
graphics.
6.
Once rasterization is complete, a sheet of print
media will feed into the printer and out onto the
Media Tray Cover, then it will retract back into the
printer and pause. When the printer pauses the
cancel and on-line LED lights will begin alternately
flashing.
7.
When these lights begin flashing, you have two
choices: 1. You may press the on-line button to
begin printing with the currently installed ribbon.
ÑorÑ 2. You may open the cover of the printer to
verify that the proper ribbon is installed or to load
another ribbon altogether. In either case, the
printerÕs cover must be closed and you must press
the on-line button to begin printing. Do not open
the cover of the printer before the cancel and on-
line lights begin flashing or after they have
stopped! This will cancel your print job. While
printing, you can only open the printerÕs cover or
change ribbons when the cancel and on-line lights
are alternately flashing.
8.
After the first color pass has printed, the print
media will again retract back into the printer and
pause, however, the cancel and on-line lights will
remain solid. Do not open the printerÕs lid to
change ribbons at this time! Remember, you can
only open the printerÕs cover or change ribbonÕs
when the cancel and on-line lights are alternately
flashing.
9.
Send the second layer of your image to the
printer by selecting Print from the programÕs File
menu.
10.
Once the image is finished rastering, the
cancel and on-line lights will once again begin
alternately flashing.
11.
Open the printerÕs cover, remove the first
layerÕs ribbon color, load the second layerÕs ribbon
color, and close the cover.
12.
Press the on-line button to begin printing the
second layer.
13.
When the second pass is finished printing, the
print media will again retract and the printer will
wait for the next layer to be sent. If you are only
printing two layers, press the cancel button to eject
your finished sign. If you are printing more than
two layers, continue this process for each
additional layer of your design.
65