Firmware Updates; Determining The Firmware Version; Using Toolbelt Software; Using A Browser - Extron electronics HC 400 Series User Manual

Firmware Updates

If the need arises, you can replace the firmware. This section covers the following aspects of
how to do that:
•
•

Determining the Firmware Version

There are several ways to check which version of firmware the receiver (or receiver and
transmitter) is using:
•
•
•
Before using any of those methods, connect the receiver and the PC to the same network.
Alternatively, for PCS, you can connect the receiver to the PC using a USB configuration
cable. For details see the
page 9, the
page 59, and the setup guide that came with the unit.

Using Toolbelt Software

1.
2.
3.

Using a Browser

The receiver comes with a set of factory default embedded web pages.
1.
2.
3.
Determining the Firmware Version
Updating the Firmware
View the device information in Toolbelt.
View the general status information section of the embedded web page for the receiver.
View the hardware unit information page within PCS.
Hardware Features and Installation
Software-Based Configuration and Control
Open the Toolbelt software.
Either add the desired HCR 102 manually or start device discovery and select the
desired unit from the list of discovered devices.
Click Manage in the row for the desired device and view the device information that
appears in that section.
Start a browser program.
Enter the IP address of the HCR 102 receiver into the address field of the browser and
log on to the internal web page.
Look for the general device or status information section.
section starting on
section starting on
HC 400 Series • Firmware Updates 80