Av Input Cabling - Extron electronics HC 400 Series User Manual

AV Input Cabling

B Analog audio input (see
page 16 and
audio sources, connect the source device to the audio
input 3.5 mm tip-ring-sleeve (TRS) connector on the
transmitter. Wire the connector as shown at right.
C
Analog video input — Connect an analog RGB video input
source to the 15-pin HD RGB input connector (see
and figure 8
Digital AV (HDMI) input (see
D
figure 10
HDMI signals (or single link DVI-D with the appropriate DVI-HDMI adapters):
1. Connect a digital video source device to any HDMI input connector on the
transmitter or receiver.
2. To secure each cable to the unit, attach
an Extron LockIt bracket to the unit and
secure it to the cable with a zip tie as
follows:
a.
b.
c.
d.
e.
Complete details on LockIt installation are
available in the LockIt HDMI Cable Lacing
Bracket Installation Guide.
figure 7
figure 9 on page 17 ) — For analog
on page 16) on the transmitter.
figure 7
on page 17) — For HDMI video and for digital audio embedded within
Plug the HDMI cable into the panel
connection (see figure 6,
a
Loosen the HDMI connection mounting
screw from the panel enough to allow
the LockIt lacing bracket to be placed
over it ( ). The screw does not have to
b
be removed.
Place the LockIt lacing bracket on the
screw and against the HDMI connector
( ), then tighten the screw to secure
c
the bracket ( ).
d
Loosely place the included tie wrap
around the HDMI connector and the
LockIt lacing bracket as shown (
While holding the connector securely
against the lacing bracket, tighten the tie
wrap, then remove any excess length.
HC 400 Series • Hardware Features and Installation
figure 8
and on
figure 7
and figure 8 on page 16 and
a
).
U T
T P
O U
3
).
e
3
Figure 11.
Tip (L)
Ring (R)
Sleeve (Gnd)
3.5 mm Stereo Plug
(unbalanced input)
figure 9 and
b
c
d
e
LockIt Bracket
Installation Steps
18