Extron electronics HC 400 Series User Manual page 71

3. If this is the first time you connect the HCR 102 to PCS, an EDID Minder library
dialog box (shown in the figure below) opens to ask you to either locate an existing set
of EDID settings or to create a new EDID library for the unit.
Figure 34. The EDID Minder Library Dialog Box
Either:
Click Browse to Locate. A dialog box opens. Browse to and select an existing
•
EDID file (.bin file type), then click the Open button.
Or...
Click the Create New button.
•
The EDID Minder dialog box closes.
An HCR 102-specific tab and Input/Output Configuration page open, showing the
settings of the connected HCR 102 and its HCT 103 or HCT 102 D, if detected.
Figure 35. The HCR 102 Input/Output Configuration Page Within PCS Software
HC 400 Series • Software-based Configuration and Control 63