Mounting The Water Pump Cover; Installing The Kickstarter; Installing The Stator; Installing The Rotor - KTM 65 SX 2009 Repair Manual

30/ASSEMBLING THE ENGINE

Mounting the water pump cover

17.16

Installing the kickstarter

17.17

Installing the stator

17.18

Installing the rotor

17.19
–
Position the clutch cover. Mount and tighten screws
Guideline
Screw, clutch intermediate cover
Info
Do not forget the spring hanger.
300772-11
–
Mount the gasket and dowels.
–
Position the water pump cover.
–
Mount and tighten screws
Guideline
Screw, water pump cover
300773-10
–
Position the kickstarter. Mount and tighten screw
Guideline
Screw, kickstarter
300771-10
–
Position the stator.
–
Mount screws
Guideline
Screw, ignition
system/stator
–
Position cable support sleeve
300769-11
–
Ensure that the spring washer is seated properly.
–
Grease the cone.
–
Mount rotor
300768-10
.

M8
, but do not tighten them yet.

M5
.

.

.

M6 10 Nm (7.4 lbf ft)
M6 8 Nm (5.9 lbf ft)
with the washer.

25 Nm Loctite ®
(18.4 lbf ft)
Loctite ®
5 Nm
(3.7 lbf ft)
78
243™
222