Operation (Hand) - Toshiba vlp technology P9 ASD Installation & Operation Manual

Hide thumbs Also See for vlp technology P9 ASD:
Table of Contents

Advertisement

Frequency Reference Source (F004)
This selection allows the user to establish the source of the Frequency command.
Settings:
Use VI/II (V/I)
Use RR
Use RX
EOI Keypad
RS485
Communication Option Board
RX2 Option (AI1)
Option V/I
UP/DOWN Frequency
Pulse Input (Option)
Pulse Input (Motor CPU)
Binary/BCD Input (Option)
Display Unit (F701)
This parameter sets the unit of measurement for current and voltage values displayed on the EOI.
Exit >>
This is the final screen of the Standard Startup Wizard. The basic parameters of the ASD have been set.
Click Exit to return to the
may be required.

Operation (Hand)

Note:
See the section titled
To turn the motor on, perform the following:
1.
Connect the CC terminal to the ST terminal.
2.
Press the Mode key until the Frequency
Command screen is displayed.
3.
Press the Hand/Auto key to enter the Hand
mode (green Hand LED illuminates).
4.
Turn the Rotary Encoder clockwise until the
desired Frequency Command value is
displayed in the SET field of the LCD screen.
5.
Press the Run key and the motor runs at the
Frequency Command value.
Note:
The speed of the motor may be changed while the motor is running by using the Rotary
Encoder to change the Frequency Command value.
6.
Press the Stop-Reset key to stop the motor.
P9 ASD Installation and Operation Manual
Frequency Command
Screen. Additional application-specific programming
EOI Features on pg. 30
for information on Auto operation.
Frequency Command Screen
39

Advertisement

Table of Contents
loading

Table of Contents