Toshiba vlp technology P9 ASD Installation & Operation Manual page 166

F393
Virtual Linear Pump Transducer Maximum Reading
Program Virtual Linear Pump VLP Settings
During a properly configured VLP operation, this parameter establishes the
maximum level of the transducer range for VLP operation.
Virtual Linear Pump Transducer Minimum Reading
Program Virtual Linear Pump VLP Settings
During a properly configured VLP operation, this parameter establishes the
minimum level of the transducer range for VLP operation.
Virtual Linear Pump Minimum
Program Virtual Linear Pump VLP Settings
During a properly configured VLP operation, this parameter establishes the
minimum setpoint within the VLP operating domain.
Virtual Linear Pump Maximum
Program Virtual Linear Pump VLP Settings
During a properly configured VLP operation, this parameter establishes the
maximum setpoint within the VLP operating domain.
Virtual Linear Pump Command Source
Program Virtual Linear Pump VLP Settings
During Direct mode or the Process Hold mode operation, this parameter sets
the VLP command source.
Note: If Process Hold is selected at F390, selecting V/I here will result
in an error message.
Settings:
0 — EOI
1 — *V/I
2 — RR
3 — Communication Board
158
Direct Access Number — F393
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — -3276.7
Maximum — 3276.7
Direct Access Number — F403
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — -3276.7
Maximum — 3276.7
Direct Access Number — F394
Parameter Type — Numerical
Factory Default — 10
Changeable During Run — Yes
Minimum — 10
Maximum — 165
Direct Access Number — F395
Parameter Type — Numerical
Factory Default — 10
Changeable During Run — Yes
Minimum — 10
Maximum — 165
Direct Access Number — F396
Parameter Type — Selection List
Factory Default — EOI
Changeable During Run — No
P9 ASD Installation and Operation Manual
F396