Toshiba vlp technology P9 ASD Installation & Operation Manual page 167

F397
Process Hold Operation VLP Command Value via the EOI
Program Virtual Linear Pump VLP Settings
During a properly configured VLP operation while operating in the Process
Hold mode and using the EOI for system control, this parameter establishes the
VLP level.
This parameter setting is effective ONLY while operating in the Process Hold
mode and while receiving a command via the EOI. The end value of this
parameter setting appears in the Frequency Command screen as shown below.
Virtual Linear Pump Low Frequency Limit
Program Virtual Linear Pump VLP Settings
During a properly configured VLP operation, this parameter establishes the
VLP Low Frequency Limit.
Autotuning 1
Program Motor Vector Motor Model
This parameter sets the Autotune command status.
Selecting Reset Motor Defaults for this parameter sets parameters F410, F411,
F412, and F413 to the factory default settings.
If selecting Autotune on Run Command, Autotune Initiated by Input
Terminal, or Autotune of Detail Parameters for this parameter set the Base
Frequency, Base Frequency Voltage, and the Motor Rated Revolutions to
the nameplated values of the motor to achieve the best possible Autotune
precision.
Settings:
0 — Autotune Disabled
1 — Reset Motor Defaults
2 — Enable Autotune on Run Command
3 — Autotuning by Input Terminal Signal (
4 — Motor Constant Auto Calculation
P9 ASD Installation and Operation Manual
See
Table 6 on pg. 249)
Direct Access Number — F397
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum — F403 Setting
Maximum — F393 Setting
Direct Access Number — F398
Parameter Type — Numerical
Factory Default — 15
Changeable During Run — Yes
Minimum — 1.00
Maximum — 60.00
Units — Hz
Direct Access Number — F400
Parameter Type — Selection List
Factory Default — Autotune Disabled
Changeable During Run — No
F400
159