Table of Contents
Advertisement
System Operation
Operation (Hand)
Note:
See the section titled
To turn the motor on, perform the following:
1.
Connect the CC terminal to the ST terminal.
2.
Press the Mode key until the Frequency
Command screen is displayed.
3.
Press the Hand/Auto key to enter the Hand
mode (green Hand LED illuminates).
4.
Turn the Rotary Encoder clockwise until the
desired Frequency Command value is
displayed in the SET field of the LCD screen.
5.
Press the Run key and the motor runs at the
Frequency Command value.
Note:
The speed of the motor may be changed while the motor is running by using the Rotary
Encoder to change the Frequency Command value.
6.
Press the Stop-Reset key to stop the motor.
P9 ASD Installation and Operation Manual
EOI Features on pg. 29
for information on Auto operation.
Frequency Command Screen
35
Advertisement
Table of Contents
