Toshiba vlp technology P9 ASD Installation & Operation Manual page 98

F040
Automatic Function Selection
Program Utilities Display Parameters
This parameter setting is used to configure multiple parameters with the setting
of only one parameter. From the selection below multiple parameters may be
set as indicated in the table.
Once set, the selected configuration is placed in effect and remains in effect
until this parameter is changed or the individual settings are changed.
Set this parameter to Disable to set these parameters individually.
Note: After performing the desired selection the EOI display returns to
Disabled though the selected function has been carried out (i.e.,
without this, if selection 1 is performed,
hold the RR terminal setting regardless of attempts to change the
settings individually).
Settings:
0 — Disabled
1 — RR
2 — V/I
3 — RR or V/I (V/I) Switched via Terminal Board
4 — Keypad = Frequency/Terminal Board = Command
5 — Keypad = Frequency and Command
0
Related Default
Disabled
Parameters Settings
Command
Terminal
Mode
Board
F003
Frequency
Mode 1 RR N/C
F004
S3 Terminal Preset
F117 Speed 3
Frequency
Terminal
Priority N/C
Board
F200
V/I Setup
0.0%
F201
Frequency
Mode 2 V/I N/C
F207
N/C = No Change — the setting remains as it was before setting parameter F040.
90
F004 and
User Settings
1 2 3
RR or V/I
RR V/I
via TB
N/C
RR N/C RR
Freq. Ref.
N/C
Priority
Terminal Board
N/C 20.0%
RR V/I
Direct Access Number — F040
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
F207 would
4 5
Keypad/
Keypad
Freq.
Freq/CMD
CMD/TB
Terminal
Keypad
Board
Keypad
N/C
N/C
Keypad
P9 ASD Installation and Operation Manual
F040