Figure 6-12：Select The Actual I-7000/Dl Modules Connected; Figure 6-13：Set Up The No. And Address Of The I-7000/Dl Modules; Figure 6-14：Select The Model Of The I-7000/Dl Modules - ICP DAS USA WISE-2841 Series User Manual

ICP DAS WISE User Manual
6.2.2 Add I-7000/DL DCON Module manually
In addition to perform Scan operation to automatically add I-7000/DL
DCON modules to the list, the user could also add the I-7000/DL
DCON module manually one by one, the steps are as below:
i. No: The number will be the order that the I/O channel data of the
I-7000/DL DCON module being stored in the WISE Modbus Table.
The range is 1~16.
ii. Address: The address will be the DCON address of this I-7000/DL
DCON module, please make sure the address is the same as the
settings of the module, if the setting is not accurate, the connection
for WISE to the I-7000/DL DCON module will be failed.
Figure 6-13：Set up the No. and Address of the I-7000/DL modules
iii. Select the module name: For ICP DAS I-7000/DL DCON modules,
the user could select the default model name from the dropdown list
for further modification.
http://wise.icpdas.com
Figure 6-12：Select the actual I-7000/DL modules connected
Figure 6-14：Select the model of the I-7000/DL modules
65