Figure 9-57："Active Sending Of I/O Data Table" Setting Page (1); Figure 9-58："Active Sending Of I/O Data Table" Setting Page (2) - ICP DAS USA WISE-2841 Series User Manual

ICP DAS WISE User Manual
vii If you want to remove all I/O channel of the I/O Data Table, please
directly click the "Remove All Setting" button which is located at the
left-lower corner of the I/O Data Table to remove all I/O channels.
viii After you finish the I/O Data Table settings, click "Save" button to save
the settings.
9.9.2 Active Sending of I/O Data Table
The settings steps are as below:
i Click on the "Sending Setting" tab at the right-upper corner of the
Active I/O Sending setting page.
Figure 9-57："Active Sending of I/O Data Table" Setting page (1)
ii Enable the "Active Sending" function, and then the setting
interface will be shown as below.
Figure 9-58："Active Sending of I/O Data Table" Setting page (2)
iii Complete the receiver‟s (SCADA software) IP address, the
Modbus TCP Slave‟s Port number, NetID and Timeout value
setting. Make sure all the setting is the same as the settings of the
receiver (SCADA software). If the setting is not accurate, the
connection for WISE to the receiver (SCADA software) will be
failed.
http://wise.icpdas.com
198