ICP DAS USA WISE-2841 Series User Manual page 181

ICP DAS WISE User Manual
with the image files to the specified LINE chat room. When users
connect WISE with iCAM series IP Cameras, the "Forward" setting
page will show the list of connected IP cameras. Users can enable the
"Forward" function to let WISE automatically send the image files of
the IP camera to the specified LINE chat room when the IP camera
triggered by the following actions:

Use IF-THEN-ELSE rule to trigger a snapshot action of the
connected IP Camera.

The events of IP Camera (Motion Detection, Tampering Detection)
are triggered and the pictures are sent to the WISE controller.
In addition, when the WISE controller connect with a CGI server (ex.
IP camera), and get the snapshots from the CGI server through CGI
commands. These files also can be forwarded to the specified LINE
chat rooms.
The forward setting of each file source is independent. When the
forward function is enabled, you have to edit an message which will be
sent with the image. The settings steps are as below:
Click on the "Forward" tab at the right-upper corner of the LINE
i
Notify setting page.
ii
To forward the desired files, please specify and click on the radio
button of the file source, and click the "Setting" button to enter the
setting page.
Check the "Enable" function, and then the message setting
iii
interface will be shown as below. Please refer to the section "9.7.1
Message Setting" to complete the setting.
http://wise.icpdas.com
181