Figure 10-38：Coil Output Action Setting Page - ICP DAS USA WISE-2841 Series User Manual

ICP DAS WISE User Manual
ii In the "Command and Channel" field, set up the Infrared
iii Specify the "Execution Frequency" to be "One Time" or
iv Click "OK" button to confirm the settings and return to the
10.2.2 Modbus Module
Click on "Modbus Module", 2 options will appear as the following: Coil
Output and Holding Register.
10.2.2.1
User can execute an action to change the status of Coil Output of
Modbus TCP/RTU module in the THEN/ELSE Action statement; the
editing page for Coil Output Action is shown as follow:
Follow the steps below:
i
ii Specify the output value of Coil Output from the dropdown list
iii Specify the "Execution Frequency" to be "One Time" or
iv Click "OK" button to confirm the settings and return to the
10.2.2.2
You can execute an action to change the value of Holding Register in
http://wise.icpdas.com
command to be sent.
"Repeat". Please refer to
for detail.
Rule settings page.
Coil Output
Figure 10-38：Coil Output action setting page
Select the module and the address of the Coil Output from the
dropdown list of the "Module & Address" section.
of the "Status" field. The output value can be "OFF" or "ON".
"Repeat". Please refer to
for detail.
Rule settings page.
Holding Register
"10.2 THEN/ELSE Action
"10.2 THEN/ELSE Action
Setting"
Setting"
240