ICP DAS USA WISE-2841 Series User Manual page 68

ICP DAS WISE User Manual
The settings are as below:
 Nickname: For user to define nickname for the module and the I/O
channels, these nicknames will be displayed on the "Channel
Status" and "Rule Setting" pages.
 Description: The Description field provides a space for the user to
make a brief description of this module.
 Address: The address will be the DCON address of this I-7000/DL
DCON module, please make sure the address is the same as the
settings of the module, if the setting is not accurate, the connection
for WISE to the I-7000/DL DCON module will be failed.
 Scan Rate: Input the time interval for WISE to periodically retrieve
the I/O channel data of this I-7000/DL DCON module, the setting
range will be 0 ~ 65535 seconds.
 Retry Interval: The time interval to wait for WISE to repeatedly
send command again when WISE sends command to the
I-7000/DL DCON module and get no response. The unit will be
second. The setting range will be 3 ~ 65535 seconds.
After all settings of the DI channels are completed, continue the
configuration of other channels, and after all channel settings are
completed, click "OK" button to save the changes and return to
I-7000/DL DCON Module List.
Please Note: For I-7000/DL DCON modules, the counting mode of the
DI channel counter is Falling. You can change the counting mode by
DCON Utility
6.3.2 The DO channel setting for I-7000/DL DCON module
The I-7000/DL DCON module DO channel setting interface is shown
as below (using I-7060 as an example):
http://wise.icpdas.com
68