Figure 20: Mounting The Outer Rails Into The Rack; Figure 21: Attaching The Inner Rails To The Chassis; Figure 22: Securing The Chassis In The Inner Rails - Mellanox Technologies Spectrum SN2700 Hardware User Manual

If cable accommodation is required, route the power cable and/or Eth cable through either
Step 3.
of the outer rails.
Attach the switch to the left and right inner rails (A+B), by gently pushing the switch chas-
Step 4.
sis' pins through the slider key holes, until locking occurs.
Secure the chassis in the inner rails by screwing the 2 flat head Phillips screws (F) in the
Step 5.
designated points with a torque of 1.5±0.2 Nm.
Slide the switch into the rack by carefully pushing the inner rails into the outer rails installed
Step 6.
on the rack.
Rev 1.9

Figure 20: Mounting the Outer Rails into the Rack

Figure 21: Attaching the Inner Rails to the Chassis

Figure 22: Securing the Chassis in the Inner Rails

Mellanox Technologies
Installation
31