Table of Contents
Advertisement
1 1 F R O N T S U R R O U N D & C O N T R O L
L I N K A G E I N S T A L L A T I O N
Figure 28. Front Surround
Top Location
Figure 29. "Visage" Front
Surround Bottom Location
Figure 30. Control Bar & Pivot
Bracket
INSTALLER'S GUIDE
11.1 Slide the control button upwards as far as it will
go. Make sure that the bottom of the linking bar is
higher than the bottom of the front surround.
11.2 Carefully lift the front surround. Do not lift it by
the control button.
11.2.2
fireplace front surface so that the two retaining
plates at the back of the surround are directly above
the two upper retaining brackets at the top of the
convection box. Lower the surround unit making
sure that the retaining plates locate fully over the
brackets on the convection box (See figure 28).
Swing the bottom control linking bar towards the
centre of the fire to clear the right side of the
surround. Slide the surround unit sideways, if
necessary, to align the bottom fixing holes with
those in the convection box. Fix the bottom of the
surround unit to the convection box with two screws
(See figure 29).
11.3 Align the hole near the bottom of the
control linking bar with that in the control pivot
bracket. Join them with the knurled shouldered
screw (See figure 30). Make sure that the
isolating valve is closed. Slide the control button
fully from top to bottom and back to make sure
that the slide and pivot mechanisms move
smoothly. Note that some resistance should be
felt when the slide button reaches the "burner
fully on" position.
Page 27
Place the front surround against the
Advertisement
Table of Contents
