Table of Contents
Advertisement
Fit the two surround securing brackets to the
convection box side flanges with the screws
supplied. Note the different orientation of the
brackets at left and right sides (See figure 16)
8 C O N V E C T I O N B O X I N S T A L L A T I O N
8.1 Method 1 - Front Fixing to Fireplace Surround
1. Make sure that the fireplace front
surround area is sound enough to take the
rawlplugs and woodscrews. If necessary,
make sound with a suitable cement.
2. Place the convection box centrally in the
fireplace in the position in which it is to be
permanently installed. If a concealed
connection is being used, insert the
convection box into the fireplace feeding the
supply pipe through the pierced hole in the
rear seal.
3. Mark the fireplace front surround through
the four fixing holes in the side flanges of the
convection box. See figure 17.
4. Remove the convection box. Drill four
holes in the fireplace front surround at the
marked positions using a no.12 masonry drill.
5. Insert a rawlplug into each hole.
6. Place the convection box back in position in the fireplace.
7. Fit a woodscrew through each hole in the convection box flanges and tighten to seal the
box to the fireplace surround.
INSTALLER'S GUIDE
Page 20
Left
Figure 16. Surround securing
brackets.
Figure 17. Front Fixing
Right
Advertisement
Table of Contents
