Fascia And Control Linkage - Valor 940 Installer And Owner Manual

2. Remove four screws
from the spillage plate sides
(See figure 30).
3. Remove the spillage
plate by lifting it forward.
4. Fit the ceramic side walls
against the side faces of
the burner compartment.
The bottom edges of the
walls should rest in the
ledges at the sides of the
firebox. Slide them in from
the front and ensure that
the touch the rear wall. The
friction between the side
walls and the rear wall
should hold the side walls
in position (See figure 30)
5. Re-fit the spillage plate.
Be careful not to damage
the edges of the side walls.
The spillage plate will hold
the side walls in place.

12. FASCIA AND CONTROL LINKAGE

Before fitting the fascia ensure that the information on the back pages of the
owner guide have been completed.
12.1 Dream fascia
1. The slider control knob is supplied separately. Fit the slider
control knob to the slider using two M4 x 7mm screws supplied
(See figure 31).
2. Assemble the fascia as shown on the fascia assembly
instruction supplied with the fascia.
©
GDC Group Ltd. 2011
INSTALLER GUIDE
Figure 30. Ceramic side walls installation
Page 31
Figure 31. Dream
slider control knob.