Table of Contents
Advertisement
You should feel some resistance when the slide button reaches the maximum burner
flame position. Sliding further upwards until the knob comes to a stop should then turn
the burner and pilot off. When the above checks have been completed close the isolating
valve on the inlet 'T' connector. If the above checks are satisfactory, continue with the
installation. If not, check the control and ignition circuitry and components as described
in the servicing section of this manual.
10.3 Inlet Pressure Check
The appliance is pre-set to give the correct heat
input at the inlet pressure shown in section 2 of
this manual. No adjustment is necessary.
1. Check the inlet pressure by fitting a pressure
gauge at the test point. The test point is on the
inlet 'T' connector. See figure 25. Check the
pressure with the appliance alight and set at
maximum output.
2. After checking, turn off the appliance. Remove
the pressure gauge and replace the test point
sealing screw.
3. Relight the appliance. Turn to the maximum output position and test around the
sealing screw for gas soundness with a suitable leak detection fluid.
11. FITTING THE FRONT SURROUND
11.1 Fitting The Front Surround
1. Locate the two lugs at the top of the front surround in
the slots in the convection box
hood. Swing the bottom of the
surround sides back against the
convection box and lower the
surround so that the lugs are fully
seated in the slots in the
convection box hood (See figure
26).
2. Refit the two screws to secure
the surround sides to the
convection box brackets (See
figure 27).
INSTALLER GUIDE
Figure 27. Outer
surround side attachment.
Page 23
Figure 25. Pressure test point
Figure 26. Fitting the front
surround
Advertisement
Table of Contents
