Table of Contents
Advertisement
1 1 F R O N T S U R R O U N D & C O N T R O L
1.
Attach the slider control to the rear of the front
surround using 2 Taptite screws (See figure 27). Slide the
control button upwards as far as it will go. Make sure that
the bottom of the linking bar is higher than the bottom of
the front surround.
2.
Carefully lift the front surround. Do not lift it by the
control button.
Place the front surround against the fireplace front surface
so that the two retaining plates at the back of the surround
are directly above the two upper retaining brackets at the
top of the hotbox. Lower the surround unit making sure
that the retaining plates locate fully into the brackets on
the hotbox (See figure 28). If the inlet pipe runs along the
front of the fireplace, the bottom of the casting will have
to be swung forwards to clear the pipe while lowering the
casting.
INSTALLER'S GUIDE
L I N K A G E I N S T A L L A T I O N
Figure 28. Front Casting Top Location
Page 28
Figure 27. Attach
slider to Firefront
Hide quick links:
Advertisement
Table of Contents
