Convection Box Installation; Method 1 - Front Fixing To Fireplace Surround - Valor 500FS Installer And Owner Manual

11. CONVECTION BOX INSTALLATION

11.1 Method 1 - Front fixing to fireplace
surround.
1. Make sure that the fireplace front surround
area is sound enough to take the wall plugs
and screws. If necessary, make sound with
suitable cement.
2. Place the convection box centrally in the
fireplace in the position in which it is to be
permanently installed. Insert the convection
box into the fireplace feeding the supply pipe
through the drilled hole in the inside rear
fitted cover plate.
3. Mark the fireplace front surround through
the six fixing holes in the side flanges of the
convection box.
4. Remove the convection box. Drill holes in the fireplace front surround at the
marked positions using a suitably sized masonry drill for the wall plugs supplied.
5. Insert a wall plug into each hole.
6. Place the convection box back in position in the fireplace.
7. Fit a wood screw through each hole in the convection box flanges and tighten to
seal the box to the fireplace surround.
11.2 Method 2 - Cable retention.
1. Make sure that the
relevant areas at the
fireplace back are
sound enough to
take the eyebolts and
screws. If this area
have deteriorated
due to prolonged use
it should be made
sound with suitable
cement.
2. Drill four holes in
the rear wall of the
fireplace for the wall
plugs. The holes
should be drilled
within the range of
positions shown,
using a suitably sized
©
GDC Group Ltd. SEPT 2016
INSTALLER GUIDE
A
Dimension
A
B
C
Page 26
B B
CL
500 mm +/-10mm
160 mm +/- 10mm
55 mm +/- 10mm
C
500FS/500RC