Table of Contents
Advertisement
Before attempting to install, it is worth
checking that the electronic ignition
system performs satisfactorily.
Fit the battery to the ignition block
●
located below the burner tray at the left
side (see figure 8). The positive
terminal (+) is to the bottom as you
insert.
Rotate the control pivot bracket as far
as it will go. This should close the
ignition circuit. Sparks should be seen
tracking from the electrode pin to the
thermocouple tip. See figure 9.
If there are no sparks make the following
●
checks.
a. Check condition of battery and that it is
correctly fitted.
b. Check spark gap between electrode
wire and thermocouple tip. See figure
10.
c. If a & b are satisfactory, check the
ignition circuit and components - see
the servicing section in this
manual.
INSTALLER'S GUIDE
5 I G N I T I O N C H E C K
Figure 10. Pilot ignition system
Page 16
Figure 8. Battery Fitting
Figure 9. Control Pivot Rotation
Advertisement
Table of Contents
