Table of Contents
Advertisement
1 3 F R O N T C A S T I N G S I N S T A L L A T I O N
13.1 Check that the two screws in the back of the fire front casting are in the outer
threaded holes. If they are in the inner holes,
relocate them. See figure 45.
13.2 Locate the two screw heads through the
keyhole slots at the inner sides of the surround. If
the screw heads do not project enough or project
too far, the screws can be adjusted. Lower the
casting so that it rests on the hearth. See figure 46.
13.3 Fit the "ash pan" cover below the front
casting locating it as shown in figure 47
INSTALLER'S GUIDE
Figure 47 "Ash pan" cover location
Page 33
Figure 45. Casting screw
position
Figure 46. Fire front casting
location
Advertisement
Table of Contents
