Procedure To Use The Automatic Clock Adjustment Function; Procedure; Settings Required For Automatic Clock Adjustment - Omron sysmac NX102-9 Series Owner's Manual

13 Automatic Clock Adjustment
13-2 Procedure to Use the Automatic
Clock Adjustment Function

13-2-1 Procedure

1
Make the basic settings.
Refer to 1-5 EtherNet/IP Communications Procedures for the flow of basic operations.
2
Select Built-in EtherNet/IP Port Settings from the Controller Setup on the Sysmac Studio,
and then set the following on the NTP Settings Display.
• NTP server settings (required)
• NTP operation timing
3
Select Synchronization from the Controller Menu. The built-in EtherNet/IP port settings are
transferred to the CPU Unit.

13-2-2 Settings Required for Automatic Clock Adjustment

The following Built-in EtherNet/IP Port Settings are made from the Sysmac Studio to use automatic
clock adjustment.
Tab page
NTP
Additional Information
Make the settings in the NTP Settings Dialog Box if automatic clock adjustment is used. Refer to
5-4 NTP Settings Display for information on the NTP Settings Dialog Box.
*1 This setting is required to get the clock information from the NTP server.
*2 The following ports are used by the system and cannot be set by the user: 25, 53, 68, 110, 2222, 2223, 2224,
9600, and 44818.
13-4
Setting
NTP server clock information
Port No.
Server specifying method
IP address
Host name
NTP operation timing
Specify a Time
Specify a time inter-
val
Timeout time
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
Setting conditions
Required.
Specified by user.
Note Required to change from the
default value of 123.
*1
Required
One of these must be set, depending on
the Server specification type setting.
*1
Required
One of these must be set. (Set according
to the option selected for the NTP Oper-
ation Timing.)
Specified by user.
Note Required to change from the
default value of 10 seconds.
Reference
page 5-10