Omron sysmac NX102-9 Series Owner's Manual page 309

Machine automation controller, cpu unit built-in ethernet/iptm port
Table of Contents

Advertisement

 Response Data Format
When the processing is successful
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
When the processing is failed
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
Additional Status
*1 When the General Status of the response code is 1F hex (Vendor specific error), becomes 01 hex.
*2 This is stored only when the Size of Additional Status is 01 hex.
 CIP Error Codes
General
status
code (hex)
02
0C
0E
10
13
15
1F
20
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
USINT
USINT
USINT
USINT
USINT
USINT
USINT
USINT
UINT
Error name
Resource unavailable
Object state conflict
Attribute not settable
Device state conflict
Not enough data
Too much data
Vendor specific error
Invalid parameter
8 CIP Message Communications
Data type
Write NX object service response: B4 hex
Reserved: 00 hex
Code indicating normal: 00 hex
Size of Additional Status: 00 hex
Data type
Write NX object service response: B4 hex
Reserved: 00 hex
Current error code defined by CIP
Size of additional status: 00 hex or 01 hex
Additional Status
Resources needed for the object to perform the requested
service were unavailable.
The object cannot perform the requested service in its cur-
rent mode/state.
The NX object which is not modifiable is specified.
• Carried out writing in a state that was not the parameter
write mode.
• The state of the NX object is not in a state to execute the
required service.
Data required for the execution of the required service is
insufficient.
Extra data for the execution of the required service is
included.
The service could not be executed due to internal reasons.
• The Unit number is out of the supported range.
• The sizes of the specified object and Length do not
match.
• The object of the index specified for the NX object does
not exist.
• The Index specified for the NX object exists but the Sub
Index does not exist.
• Write data is out of the range.
Description
Description
*1
*2
Cause
8
8-53

Advertisement

Table of Contents
loading

Table of Contents