Omron sysmac NX102-9 Series Owner's Manual page 292

8 CIP Message Communications
General status
code (hex)
08
09
0A
0B
0C
0D
0E
0F
10
11
12
13
14
15
16
17
18
19
1A
1B
1C
1D
1E
1F
20
8-36
Status name
Service not supported
Invalid attribute value
Attribute list error
Already in requested mode/state
Object state conflict
Object already exists
Attribute not settable
Privilege violation
Device state conflict
Reply data too large
Fragmentation of a primitive value The service specified an operation that is going to frag-
Not enough data
Attribute not supported
Too much data
Object does not exist
Service fragmentation sequence
not in progress
No stored attribute data
Store operation failure
Routing failure (request packet
too large)
Routing failure (response packet
too large)
Missing attribute list entry data
Invalid attribute value list
Embedded service error
Vendor specific error
Invalid parameter
Description of status
The requested service was not supported or was not
defined for this object class/instance.
Invalid attribute data was detected.
An attribute in the Get_Attribute_List or Set_Attribute_List
response has a non-zero status.
The object is already in the mode/state being requested
by the service.
The object cannot perform the requested service in its cur-
rent mode/state.
The requested instance of object to be created already
exists.
A request to modify a non-modifiable attribute was
received.
A permission/privilege check failed.
The device's current mode/state prohibits the execution of
the requested service.
The data to be transmitted in the response buffer is larger
than the allocated response buffer.
ment a primitive data value, i.e. half a REAL data type.
The requested service did not supply enough data to per-
form the specified operation.
The attribute specified in the request is not supported.
The service supplied more data than was expected.
An object that does not exist was specified for the
requested service.
The fragmentation sequence for this service is not cur-
rently active for this data.
The attribute data of this object was not saved prior to the
requested service.
The attribute data of this object was not saved due to a
failure during the attempt.
The service request packet was too large for transmission
on a network in the path to the destination. The routing
device was forced to abort the service.
The service response packet was too large for transmis-
sion on a network in the path from the destination. The
routing device was forced to abort the service.
The service did not supply an attribute in a list of attributes
that was needed by the service to perform the requested
behavior.
The service is returning the list of attributes supplied with
status information for those attributes that were invalid.
An embedded service resulted in an error.
A vendor-specific error occurred. The Additional Code
Field of the error response defines the error. This is a gen-
eral error code that is used only for errors that do not cor-
respond to any of the error codes in this table and are not
in an object class definition.
A parameter for the requested service is invalid. This code
is used when a parameter does not meet the requirements
of the specification and/or the requirements defined in an
application object specification.
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)