Omron sysmac NX102-9 Series Owner's Manual page 321

NX Unit
Parameter name
Index
Unit number
Event priority
Event occurred time
Product code
Event code
Additional information[0]
to
Additional information[31]
 CIP Error Codes
General
status
code (hex)
02
0C
13
15
1F
20
 Method of Use
1
The following variables are generated and initialized to 0.
• Total number of readout records (UINT)
• Record index during the previous readout (UDINT)
• Previous latest record index (UDINT)
2
Specify the following parameters and execute Get event log(3B hex).
• Unit No: Unit number subject to event information readout
• Start number of read record: 0
• Number of read record: Number of read records
3
The following parameters are read from the response data.
• Number of registered record
• Latest index of registered record
• Last index of readout record
• Number of readout record
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
UDINT
USINT
USINT
UDINT
UDINT
UDINT
Array of BYTE
Error name
Resource unavailable
Object state conflict
Not enough data
Too much data
Vendor specific error
Invalid parameter
8 CIP Message Communications
Data type
Current error index number
This number is assigned when system event logs
and access event logs are registered.
Unit number
0000 hex: Controller
0001 to 0020 hex: NX Unit
Event level
Event occurred time
Product code of the Unit in which event occurred
Event code
Attached information (system information) of
event.
Resources needed for the object to perform the requested
service were unavailable.
The object cannot perform the requested service in its cur-
rent mode/state.
Data required for the execution of the required service is
insufficient.
Extra data for the execution of the required service is
included.
The service could not be executed due to internal reasons.
• The Unit number is out of the supported range.
• The specification of the number of readout records is out
of the range.
• The Unit does not exist.
Description
Cause
8
8-65