Omron sysmac NX102-9 Series Owner's Manual page 313

When the processing is failed
Parameter name
Reply Service
Reserved
General Status
Size of Additional Status
Additional Status
*1 When the General Status of the response code is 1F hex (Vendor specific error), becomes 01 hex.
*2 This is stored only when the Size of Additional Status is 01 hex.
 CIP Error Codes
General
status
code (hex)
02
0C
10
13
15
1F
20
Read Total Power On Time (Service Code: 38 hex)
Read the total power on time of the specified NX Unit.
 Request Data Format
Parameter name
Service
Request Path Size
Request Path
Unit No
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
USINT
USINT
USINT
USINT
UINT
Error name
Resource unavailable
Object state conflict
Device state conflict
Not enough data
Too much data
Vendor specific error
Invalid parameter
USINT
USINT
Padded EPATH
UINT
8 CIP Message Communications
Data type
Switch parameter write mode service response:
B7 hex
Reserved: 00 hex
Current error code defined by CIP
Size of Additional Status: 00 hex or 01 hex
Additional Status
Resources needed for the object to perform the requested
service were unavailable.
The object cannot perform the requested service in its cur-
rent mode/state.
This service could not change because the transition to the
parameter write mode is in progress.
Data required for the execution of the required service is
insufficient.
Extra data for the execution of the required service is
included.
The service could not be executed due to internal reasons.
• The Unit number is out of the supported range.
• The Unit does not exist.
Data type
Read total power on time service: 38 hex
Size of Request Path: 02 hex
Request path: 2074 2401 hex
Class ID: 74 hex
Instance ID: 01 hex
Unit number
0001 to 0020 hex: NX Unit
0000, 0021 hex or above: Not supported
Description
*1
*2
Cause
Description
8
8-57