Setup; Unpacking; Setting Up The Reader - Datalogic Gryphon I GM440 Series Product Reference Manual

Unpacking

Check carefully to ensure the reader and any accessories ordered are pres-
ent and undamaged. If any damage occurred during shipment, contact Dat-
alogic Technical Support. Information is shown on
KEEP THE PACKAGING. Should the unit ever require service, it should be
returned in its original shipping container.

Setting Up the Reader

Depending on whether you are using a Corded or BT version of the Gryphon,
follow the steps provided in this section to connect and get your reader up
and communicating with its host.
1. Begin by
2. Go to
3.
4. Go to
Product Reference Guide
Installing the Interface Cable
Station (BT)
Interface Selection
Configure Interface Settings
interface)
Configuring Other Features
factory settings)
According to recent modification of Regulation for shipping Li-Ion based
battery packs, the products and their spare battery packs parts are shipped
with a very low residual charge (low state of charge).
Hence the needs:
* that a new product must be fully recharged before starting to use it
and
* that battery packs of the stocked products GBT/GM44 and spare battery
pack parts must be periodically recharged : for instance by using a BC40xx
cradle powered up with a 12V Datalogic AC/DC adapter (cod. 8-0935) for at
least 30 minutes each 3 months.
(Corded) or
and set the desired interface.
(only if not using factory settings for that
(if modifications are needed from
Chapter 2

Setup

page 2.
Connecting the Base
9