Replacing The 12Vdc Power Supply; Replacing Face Air Vent(S) - Wellness Cocoon Fitness Pod Owner's Manual

Vibration Motor Replacement Steps:
1. Install replacement vibration motor(s) using two (2) flange bolts. Apply Loctite threadlocker or
similar product to threads prior to insertion.
2. Affix bed support cup to bottom of bed with four Phillips screws.
3. Reinstall strain relief on vibrator motor power cord and affix to bottom of bed in appropriate
pattern with screws.
4. Re-install motor guards. Check to be sure motor can spin freely within motor guard

7.10 Replacing the 12VDC Power Supply

1. Unplug the vibration bed cords and remove the vibration bed.
2. Remove four screws on the electrical panel.
3. Lifted the electrical panel to get access to the power supply.
4. Disconnect the connectors/lugs on the power supply to remove it from the cavity.
5. Place the replacement Power Supply at the same location of the old one, reconnect the
connectors/lugs
6. Close the electrical panel and tighten the screws to secure the panel.

7.11 Replacing Face Air Vent(s)

Tools Required:
1. Small Flat Blade Screwdriver
2. Small Phillips Screwdriver
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.9.4
Removing Flange Bolt Attaching Motors.
49