Replacing The Heater Assembly - Wellness Cocoon Fitness Pod Owner's Manual

7.3 Replacing the Heater Assembly

Precautions:
1. Turn OFF main power switch located under contour bed on top of power box, or disconnect
from main power source.
2. Two people are needed to perform parts of this procedure (hood removal). One person can
perform heater exchange.
Tools Required: Adjustable wrench, ½ inch wrench, medium/large Phillips head screwdriver.
Preliminary Procedures:
1. Prepare work area: Place a large soft cushioned pad on the floor or an elevated platform
next to the Cocoon Pod for easier work access.
2. Remove hood: (See Section 7.1) Place exterior shell of the hood curved side down on a
cushioned pad to prevent damage as shown in Figure 7.1.4 The Hood.
Removing the Heater Assembly:
1. To release heater assembly from hinge plate
Use a Phillips head screwdriver or screw gun to release the heater assembly bracket by
removing the center screws and nuts positioned on each side of the strut opening. Place hand
inside opening, beneath bolt position, to catch nut as it releases.
CAUTION: Do not drop screws or nuts into heater channel of hood.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.3.1 Upside Down Hood Position.
38